Note: The LoadMaster LM-XHC20-NG hardware is only available in the Asia-Pacific (APAC) region.

Port Location - Front Panel

Item No. Item Description Notes
1. RAID (Dual HDD) RAID 0 (mirroring) Hot-Swap Disk (x2) Disk mirroring - replicating of data to two or more disks
HDD LED - Green Indicates HDD operating normal
HDD LED - Red Indicates possible HDD issue (contact Progress Kemp Customer Support)
Rebuild LED - Blinking amber Indicates HDD rebuilding process (could take several hours to complete)
2. ERR LED Error LED - off Indicates that the Power Supply Unit (PSU) status is normal
Error LED - red (blinking) Indicates PSU failure - either one or both (contact Progress Kemp Customer Support)
STBY LED Standby LED - Amber Indicates always-on
HDD LED LED - Green (blinking) Indicates HDD read/write activity
LED - Off Indicates no data transferring
PWR LED LED - Green Power on indicator
LED - Red (blinking) Indicates hardware monitor abnormality (contact Progress Kemp Customer Support)
LED - Off Power off indicator
3. USB-C type Console Port Used to connect console devices with USB-C type connection

Used to connect console
4. Reset Reset the LoadMaster Software reset
5. HDMI connector High-Definition Multimedia Interface Used to connect a HD monitor
6. USB ports USB 3.0 ports (x2) Allows USB devices to connect to the system
7. 25 Gb Fibre SFP28 ports 25 Gb Fibre SFP28 ports (x4) Requires SFP28 transceiver modules (purchase from Progress Kemp)

Logical Assignment

Port 4:7 map to ETH4:ETH7
Activity LED - Blinking Indicates network activity
Activity LED - Off Indicates no network activity
Link LED - On Link - Continuously illuminated
Link LED - Off No link (cable disconnected)
8. 10 Gb Fibre SFP+ Ports 10 Gbps Fibre SFP+ Ports (x4) Requires SFP+ modules (purchase from Progress Kemp)

Logical Assignment

Port 8:11 map to ETH8:ETH11
Activity LED - Blinking Indicates network activity
Activity LED - Off Indicates no network activity
Link LED - On Link - Continuously illuminated
Link LED - Off No link (cable disconnected)
9. 1 Gb Ethernet Ports 1 GbE Copper (RJ-45) Ports (x4) Logical Assignment

Port 0:3 map to ETH0:ETH3

Activity LED - Blinking Indicates network activity
Activity LED - Off Indicates no network activity
Link LED - On Link - Continuously illuminated
Link LED - Off No link (cable disconnected)

Port Location - Rear Panel

Item No. Item Description Notes
10. Power switch On/off switch Press to power on or hold until the device powers off
11. Dual Hot-Swap Power Supply 550W 1+1 redundant power supply Contact Progress Kemp Customer Support before removing Power Supplies
LED - Green Indicates power on mode
LED - Blinking green Indicates standby mode
LED - Blinking Red with high pitch sound Indicates loss of power supply redundancy and/or issue with power supply