Once the server boots from the virtual CD, as described in the Boot the Server section, the LoadMaster installation process automatically begins.

Note: For further information on the different boot options that are available, refer to the Bare Metal Boot Options, Technical Note.
Note: In the vast majority of cases, the serial number should be automatically pulled from the LoadMaster. If it is not, please enter it when prompted. The location of the serial number varies by make and model, but usually there is a pull tab on the front of the device which lists the serial number.

  1. Select select disk/partition and press OK.

  2. Select the target disk for installation and press OK.

  3. Select delete existing partition(s) and press OK.

  4. Select start installation and press OK.

When prompted, press OK to continue.

The installation then completes as shown in the screenshot below.