ECS Connection Manager H2
- Last Updated: August 6, 2025
- 1 minute read
- ECS Connection Manager
- Documentation
| Item No. | Item | Description | Notes |
|---|---|---|---|
| 1. | RAID (Dual HDD) | RAID 1 (mirroring) hot-swap disk (x2) |
Disk mirroring - replicating of data to two or more disks |
| HDD LED - Green | Indicates HDD operating normal | ||
| HDD LED - Red | Indicates possible HDD issue (contact Progress Kemp Support) | ||
| Rebuild LED - Blinking amber | Indicates HDD rebuilding process (could take several hours to complete) | ||
| 2. |
ERR LED |
Error LED - Red |
Indicates the system is experiencing an error during operation (contact Progress Kemp Support) |
| STBY LED |
Standby LED - Amber |
Indicates the system is on |
|
| HDD LED |
LED - Amber LED - Off |
Indicates HDD activity Indicates no HDD activity |
|
| PWR LED |
LED - Green LED - Off |
Power on indicator Power off indicator |
|
| 3. | Console port | Console connection | Allows console devices to connect to the system |
| 4. | USB Ports | USB 3.0 Ports (x2) | Allows USB devices to connect to the system |
| 5. | 1Gb Ethernet Ports |
1GbE copper (RJ-45) ports (x2) |
Logical Assignment Port 0:1 map to ETH0:ETH1 |
| Activity LED - Blinking | Indicates network activity | ||
| Activity LED - Off | Indicates no network activity | ||
| Link LED - On | Link - connection established | ||
| Link LED - Off | No link (cable disconnected) | ||
| 6. | Reset | Reset ECS Connection Manager | System reset |
| 7. | 10Gb SFP+ ports |
10Gbps SFP+ ports (x12) |
Requires SFP+ transceiver modules (purchase from Progress Kemp) Logical Assignment Port 2:13 map to ETH2:ETH13 |
| Activity LED - blinking | Indicates network activity | ||
| Activity LED - off | Indicates no network activity | ||
| Link LED - on | Link - connection established | ||
| Link LED - off | No link (cable disconnected) |
Port Location - Rear Panel
| Item No. | Item | Description | Notes |
|---|---|---|---|
| 8. | VGA port | Standard VGA interface | Used to connect a VGA monitor |
| 9. | Power switch | On/off switch | Press to power on or hold until the device powers off |
| 10. | USB ports | USB 2.0 Ports (x2) | Allows USB devices to connect to the system |
| 11. | Dual hot-swap power supply | 700W 1+1 redundant power supply | Power source for the system, refer to item 2 for status LED Indicators. |
| LED - Green | Indicates power on mode | ||
| LED - Blinking green | Indicates standby mode | ||
| LED - Amber | Indicates loss of power supply redundancy and/or issue with power supply |