Lync Reverse Proxy HTTP Virtual Service

To configure a Virtual Service for Lync Reverse Proxy HTTP, follow the steps below:

1. Click the Add New button.

   

2. Enter a Virtual Address.
3. Enter 80 in the Port field.
4. Enter a recognisable Service Name, for example Lync Reverse Proxy HTTP.
5. Ensure that TCP is set as the Protocol.
6. Click Add This Virtual Service.
7. Configure the settings as recommended in the following table:

   Section	Option	Value	Comments
   Standard Options	Force L4	Disabled
   	Transparency	Disabled
   	Persistence Mode	Source IP Address
   	Persistence Timeout	20 Minutes
   	Idle Connection Timeout	1800	Click Set Idle Timeout.
   Real Servers	Real Server Check Method	TCP Connection Only
   	Checked Port	5061	Click Set Checked Report.

8. Add the Real Servers.
   1. Click the Add New … button to add a Real Server.
   2. Enter the Real Server Address.
   3. Enter 8080 as the Port.
      Note: Ensure to not use 80 as the Real Server Port.
   4. Click the Add This Real Server button.