Remote GEO LoadMaster Access

Set the addresses of the GEO LoadMasters that can retrieve service status information from this LoadMaster. The addresses are space separated. When in HA mode, only the shared address needs to be entered.

Note: The Set GEO LoadMaster access and Set GEO LoadMaster Partners buttons will be greyed out if the Partner Shared Secret is not set. For further details, refer to the following section: Partner Communications.

GEO LoadMaster Partners

Note: GEO functionality comes as part of the GSLB Feature Pack and is enabled based on the license that has been applied to the LoadMaster. If you would like to get the GSLB Feature pack, contact Progress Kemp to upgrade your license.

Set the addresses of the partner GEO LoadMasters. The addresses are space separated. These GEO LoadMasters will keep their DNS configurations in sync.

Note: Before partnering GEO LoadMasters, a backup should be taken of the relevant GEO LoadMaster which has the correct/preferred configuration. This backup should then be restored to the other LoadMasters that will be partnered with the original LoadMaster. For more information and step-by-step instructions, refer to the GEO, Feature Description.
Note: Up to 64 GEO HA partner addresses can be added.

GEO LoadMaster Port

The port over which GEO LoadMasters will use to communicate with this LoadMaster unit.

GEO update interface

Specify the GEO interface in which the SSH partner tunnel is created. This is the interface that the GEO partners will communicate through.