If MOVEit WAF does not automatically obtain an IP address using DHCP, or if you would prefer to configure MOVEit WAF using the console, then you must complete the following configuration steps before starting MOVEit WAF.

1. Log in into MOVEit WAF using the console with the following settings:

   • lb100 login: bal

   • Password: 1fourall

     

2. Enter the IP address of the eth0 interface, the network facing interface of MOVEit WAF, in the input field within the IP address dialog box.
3. Press OK.

   

4. Enter the IP address of the default gateway in the input field of the Default Gateway dialog box.
5. Press OK.

   

6. Enter a space separated list of nameserver IP addresses.

   

7. Enter the HTTP(S) proxy server and port (if required).
8. Once these are set, a prompt will appear asking to connect to the web interface at the newly configured IP address. In an internet browser enter the IP address of the eth0 entered in Step 2.
   Note: Ensure to enter https:// before the IP address.
9. A warning may appear regarding website security certificates. Click the continue/ignore option to proceed.
10. The MOVEit WAF End User License Agreement (EULA) screen appears.
11. Read the license agreement and (if you are willing to accept the conditions), click Agree to proceed.
12. If the machine has shipped with a temporary license, a warning appears informing that a temporary license has been installed on the machine and for how long the license is valid.
13. Click OK.
14. The home screen of MOVEit WAF should appear.

MOVEit WAF is now fully installed and ready to use.