This performance monitor report graphs custom performance monitor values over a selected period of time.

  • Configure the data collection for a device by selecting a device from the Device list and selecting Properties > Performance Monitors, then selecting the monitor you want to apply to the device.
  • Configure the data collection for a group by selecting a group from the Device list, selecting Bulk Field Change > Performance Monitors, and then selecting the monitor you want to apply to the group.

Monitor report body for group reports

The group report displays a list of all devices in the group and the custom monitor applied to each device. To view the custom monitor data for each device, click the link to the right of the device name in the Monitors column.

Monitor report body for device reports

  • Below the date/time picker, Monitor, and Chart size boxes is a graph showing the chosen monitor for the selected time period. Each point on the graph corresponds with an entry in the graph data table below.

Split Second Graph - Real Time

Under the main report graph is a Split Second Graph that displays real-time data for the WMI or SNMP custom performance monitor.

註: Split Second Graphs are not available in the Standard Edition.

Split Second Graphs are not available in VMware host reports.

When viewing information for devices running Microsoft Windows, information gathered via WMI is displayed in real time. Information gathered by SNMP, however, may reflect a delay of one minute or more. This delay is caused by a limitation in how often Microsoft Windows updates SNMP values.

註: Split Second Graphs are not available with Active Script performance monitors.

At the bottom of the graph, the report displays the average monitor percentages collected during the time period:

  • Minimum. The minimum monitor percentage experienced.
  • Maximum. The maximum percentage experienced.
  • Average. The average monitor percentage across all sample data for this period.
註: Values displayed in the graph are the average values for the selected time period. Values displayed in the summary are the minimum, maximum, and average values for the selected time period. If raw polling data has been averaged into hourly or daily summarized data, the values for min and average, or maximum and average can be different. In some cases, they may be very different if there was a period of time when polled values were much higher or lower than normal.
註: You can verify your report rollup settings on the console via Program Options > Report Data.

  • 導覽

    • 若要變更查看的設備，請按一下目前架構下的群組或設備名稱，然後在設備選擇程式中選取新設備。
    • 選取其他報表按鈕可切換到其他設備的監控工具報表。

變更圖表外觀

按一下 [圖表設定] 按鈕可變更報表圖表的顯示方式。

裝置屬性

若要查看目前設備的設定，請按一下網頁最上方應用程式列中的 [設備設定] 按鈕。