Interface Errors report reveals packet discard count (specially due to error) for network interfaces associated with each device or device group you specify. Packets can be routinely discarded due to policy, hardware faults, and network outages. Interface Errors reports reveal an error-specific fraction of the total packet discard count reported in the Interface Discards report. At the network interface, discards due to error typically occur when a CRC (Cyclic Redundancy Check) or packet header inspection returns unexpected results.

了解列数据

每个报告的默认视图包含一个有以下列的网格：

  • Device.

    设备主机名、IP 地址或自定义标签。

  • Interface. Network interface with reported errors.
  • Rx Avg. Average incoming packets discarded due to error per minute for Date Range specified.
  • Rx Errors. Errors reported from inbound packets since polling began for Date Range specified.
  • Tx Avg. Average number of outgoing packets discarded due to error per minute for Date Range specified.
  • Tx Errors. Errors reported from inbound packets since polling began for Date Range specified.

  • 上次轮询。上次采样后的持续时间。

要显示其他度量结果，单击选择的列表 () 的列标题 () 。也可以包括：

  • 接收最小值。收到的最小平均值。

  • 接收最大值。收到的最大平均值。

  • 传输最小值。已传输最小平均值。

  • 传输最大值。已传输最大平均值。

    Generate a report

    Choose Device. Choose one or more host devices you want WUG17.0N-EMBEDDED-REPORT-BULLET-BASE-Pick Device measurements for.

    Choose time constraints. (,) Choose times for the WUG17.0N-EMBEDDED-REPORT-BASE. (For recently observed measurements, select Last Polled from the Date Range drop down list.) Filter and reduce by row and by column. Sort and remove columns, group rows based on specific column values, and remove unwanted information from the table.

    Chart, adjust output, and visualize. Fine tune report presentation and range of values displayed using the Report Setting dialog (optional).

    注： This report only returns EMBEDDED-REPORT-4E-BASE-NETWORK-ERRORS metrics for devices that already have the appropriate WMI or SNMP credentials. For more information, see Using Credentials.

注： To harvest data for this report, you must enable collection of Interface Utilization performance monitor data collection under Device Properties and ensure the Collect errors and discards data for all selected interfaces interface data collection configuration option is selected .

  • 导出报表数据

    报告数据可以从 WhatsUp Gold 导出、重复使用和以多种格式分发。从“仪表板选项”() 菜单中选择展开 ()。在展开报告后，选择“导出数据”图标以访问以下选项：