This performance monitor report graphs custom performance monitor values over a selected period of time.

  • Configure the data collection for a device by selecting a device from the Device list and selecting Properties > Performance Monitors, then selecting the monitor you want to apply to the device.
  • Configure the data collection for a group by selecting a group from the Device list, selecting Bulk Field Change > Performance Monitors, and then selecting the monitor you want to apply to the group.

Monitor report body for group reports

The group report displays a list of all devices in the group and the custom monitor applied to each device. To view the custom monitor data for each device, click the link to the right of the device name in the Monitors column.

Monitor report body for device reports

  • Below the date/time picker, Monitor, and Chart size boxes is a graph showing the chosen monitor for the selected time period. Each point on the graph corresponds with an entry in the graph data table below.

Split Second Graph - Real Time

Under the main report graph is a Split Second Graph that displays real-time data for the WMI or SNMP custom performance monitor.

注： Split Second Graphs are not available in the Standard Edition.

Split Second Graphs are not available in VMware host reports.

When viewing information for devices running Microsoft Windows, information gathered via WMI is displayed in real time. Information gathered by SNMP, however, may reflect a delay of one minute or more. This delay is caused by a limitation in how often Microsoft Windows updates SNMP values.

注： Split Second Graphs are not available with Active Script performance monitors.

At the bottom of the graph, the report displays the average monitor percentages collected during the time period:

  • Minimum. The minimum monitor percentage experienced.
  • Maximum. The maximum percentage experienced.
  • Average. The average monitor percentage across all sample data for this period.
注： Values displayed in the graph are the average values for the selected time period. Values displayed in the summary are the minimum, maximum, and average values for the selected time period. If raw polling data has been averaged into hourly or daily summarized data, the values for min and average, or maximum and average can be different. In some cases, they may be very different if there was a period of time when polled values were much higher or lower than normal.
注： You can verify your report rollup settings on the console via Program Options > Report Data.

  • 导航

    • 若要变更查看的设备，请单击当前架构下的群组或设备名称，然后在设备选择程序中选择新设备。
    • 选择其他报表按钮可切换到其他设备的监控工具报表。

变更图表外观

单击 “图表设定” 按钮可变更报表图表的显示方式。

设备属性

若要查看当前设备的设定，请单击网页最上方应用程序行中的 “设备属性” 按钮。